Epson Stylus Photo RX600 Start Here Manual
Epson Stylus Photo RX600 Start Here Manual

Epson Stylus Photo RX600 Start Here Manual

C11c543001
Hide thumbs Also See for Stylus Photo RX600:

Advertisement

Epson Stylus
Start
Start
Here
Here
®
Photo RX600
CPD-17415
4048047-00
XXX

Advertisement

Table of Contents
loading

Summary of Contents for Epson Stylus Photo RX600

  • Page 1 ® Epson Stylus Start Start Here Here Photo RX600 CPD-17415 4048047-00...
  • Page 2 Unpack Make sure you have all the parts shown here. If any parts are missing, contact Epson ® Epson Stylus Photo RX600 Paper support Remove all the tape, foam, and protective plastic from the top of the RX600. as described on the back of this sheet.
  • Page 3: Unlock The Scanner

    Unlock the Scanner Open the scanner lid. Remove the white instruction sheet covering the scanner glass. Slide the transportation lock to the Caution: You must unlock the scanner, or it won’t work. Store the Film Holder Slide the document mat handle to the left and remove the document mat. To store the film holder behind the mat, hold it so the labeling faces out and insert the tabs in the notches inside the scanner lid.
  • Page 4: Plug In And Turn On

    Unlock the Printer Lift up the entire scanner unit using the handles on the side. Remove the clear plastic sheet inside. Remove the orange plastic print head lock and store it in the storage area. Caution: You must remove the orange print head lock or the RX600 won’t work.
  • Page 5: Load Paper

    Open the cartridge cover by pulling it toward you. Remove the ink cartridges from their packages. Caution: You must install all the cartridges and leave them installed for all types of printing. To avoid damaging the RX600, never move the print head by hand.
  • Page 6: Connect To Your Computer

    Click Cancel on each of these screens and disconnect the RX600. You can’t install your software that way. Insert the Epson CD-ROM in your CD-ROM or DVD drive. Note: If you’re using Windows XP and you see a message asking what to do with your CD, click Cancel.
  • Page 7 When installation is finished, click Exit. You see the product registration screen. Register your RX600 with Epson as instructed, then remove the CD-ROM. Connect the USB cable extending from the RX600 to any open USB port on your Macintosh. Also make sure the RX600 is turned on.
  • Page 8: Any Problems

    Note: If you see a screen asking if you’d like to add a printer, click Add. On the Printer List screen, click the Add button. On the next screen, select EPSON USB from the pull-down menu. Click Stylus Photo RX600.
  • Page 9: Any Questions

    T048220 Black Cyan Epson and Epson Stylus are registered trademarks, and Epson Smart Panel is a trademark of Seiko Epson Corporation. Epson Store and SoundAdvice are service marks of Epson America, Inc. General Notice: Other product names used herein are for identification purposes only and may be trademarks of their respective owners.

Table of Contents