Fig. 31; Power Cord - Electrolux EW30DF65GS Installation Instructions Manual

INSTALLATION INSTRUCTIONS FOR FREESTANDING DUAL FUEL
Range installations steps
A
Install the power cord.
The rear access cover must be removed. To remove, loosen
center screw (one screw) and remove access cover. The
terminal block will then be accessible (See Fig. 30).
Fig. 30
Fig. 29

Fig. 31

Wiring instructions
B
(4-wire connection - See fig. 33)
Before wiring the range review the suggested power
source location drawing in Fig. 2. If connecting to a 4-Wire
electrical system (new branch-circuit or mobile home
requires 4-Wire connection):
Power cord instructions
1. Follow the manufacturer's installation instructions
supplied with the strain relief and install (Also see
Figs. 29, 30, 31 & 32).
2. Insert the end connectors for Line 1, Line 2 and Neutral
and tighten securely to the terminal block.
IMPORTANT NOTE: DO NOT LOOSEN the factory
installed nut connections which secure the range
wiring to the terminal block. Electrical failure or loss of
electrical connection may occur if these 3 nuts are
loosened or removed.
3. You must disconnect the ground strap. Remove
the factory installed ground screw & plate to release
the copper ground strap from the frame of the
appliance. Cut and discard the copper ground strap &
plate. KEEP the ground screw.
4. Connect the ground wire (Green) lead with the eyelet to
the frame of the appliance with the ground screw using
the same hole in the frame where the ground screw
was originally installed (See Fig. 33).
5. Make sure all screws are tightened securely and
replace the rear access cover (See Fig. 30).
Fig. 32
7