Table of Contents
Advertisement
EMPTY WASTE BIN
1. Unplug the shredder power cord from the electrical outlet.
2. Remove the shredder head from the waste bin by lifting the handle straight up.
3. Empty the waste bin.
4. Replace shredder head on waste bin.
5. Plug shredder power cord back into outlet.
CLEARING PAPER JAMS
Clearing Manual Feed Paper Jams:
To clear a paper jam from the manual feed opening, simply switch the function
button to the reverse position (REV) and manually pull out the paper in the feed
opening to clear the jam. Once the paper is removed, switch the function button
back to the AUTO position and resume shredding.
Clearing Auto Feed Paper Jams:
1. Move the Power Slide Switch to the OFF Position, and unplug your shredder.
2. Facing the Panel located right under the Auto Feed opening, locate the access
knob in the center of the panel and twist it to the unlock position and hold it.
3. While holding the access knob in the unlock position, gently lift and pull the
bottom section of the panel away from the shredder head. This will give you full
access to the feed opening area.
4. Remove all jammed paper and any paper residue that is causing the jam.
5. After finishing to clear the jam, twist the access knob to the unlock position and
hold it.
6. While holding the access knob, replace the panel back into it's original position,
making sure that it is seated properly in its designated recessed area on the
shredder head. Make sure that the side connecting pins are properly inserted.
7. Release the access switch and twist it back to the lock position.
8. Confirm that the panel is locked in position by checking to be sure that it
cannot be moved. (Please note that the Shredder will not power up if the panel
is not properly seated and locked in place)
9. Replug your shredder into the power outlet and move the Power Slide Switch to
the AUTO Position You should now be able to start shredding again.
OVERHEAT PROTECTION
1. Frequent or continuous use may cause motor to exceed normal operating
2. Overheat and bin-full use the same light. When the light is blue, it means the bin is full.
When the light is red, it means it's overheated.
3. Auto feed mode: After approximately 12 minutes of continuous operation,
the overheat protection feature causes motor to shut off.
Manual feed mode: After approximately 5 minutes of continuous operation,
the overheat protection feature causes motor to shut off.
4. Unplug the shredder power cord from the electrical outlet and allow shredder
motor to cool (approximately 60 minutes to completely cool).
5. Once the motor has cooled it will return to normal operation.
3
temperature.
Advertisement
Table of Contents
