NEC Express5800 Series Manual page 25

Page.25
Notes on using N8403-059F RAID Controller kit (512MB, RAID 0/1)
To start the RAID system configuration utility (WebBIOS) when you use "Storage and I/O Blade" on the server with
"N8403-059F RAID Controller kit (512MB, RAID 0/1)" installed and "Option ROM Scan" of "Storage and I/O Blade" is set to
"Enabled" in the system BIOS, do as follows.
1. When POST is running and the following screen is displayed, do as follows.
LSI MegaRAID SAS-MFI BIOS
Version X.XX.XX (Build Xxxxx XX, 20XX)
Copyright(c) 20XX LSI Corporation
HA -0 (Bus XXX Dev X) LSI MegaRAID SAS 9267-8i
FW package: XX.X.X-XXXX
...
...
Press <Ctrl><H> for We
2. Make sure that you do not press any key before beginning this work.
3. Press "<CTRL> Key" first, and then press "<H> Key" with "<Ctrl> Key" pressed repeatedly until the utility (WebBIOS)
starts.
4. When the utility (WebBIOS) has started, confirm whether the utility (WebBIOS) is correct or not.
If a wrong utility (WebBIOS) has started or the correct utility (WebBIOS) has failed to start, please restart the server
and rerun POST to try again.
Correct utility
Two RAID controllers are recognized.
"LSI MegaRAID SAS 9267-8i" indicates
"N8403-059F RAID Controller kit",
and the other indicates the RAID controller
of "Storage and I/O Blade AD106ｃ".
Select a configuration type, and click [Start].
For the steps to proceed, refer to the user's
guide.
Wrong utility
Only one RAID controller is recognized.
In this case, please restart the server
and rerun POST to try again.
bBIOS
Please confirm that
"LSI MegaRAID SAS 9267 -8i"
th
is displayed in the 4 row. If any different information
is displayed, do not enter any key.