Installation Procedure; When Attaching To The Finisher (Without A Saddle Unit) - Canon Unit-BF1 Service Manual

4

Installation Procedure

When attaching to the finisher (without a saddle unit)

1
MEMO:
1) Open the front door of the finisher.
•
The equipment is se-
cured with packaging
tapes and cushioning
materials to protect it
against vibration and
shock during trans-
portation. Remove all
packaging tapes and
cushioning materials
before installing the
equipment.
•
When attaching to
the saddle finisher,
refer to B, "When at-
taching to the saddle
finisher".
3
3) Using a nipper, cut out the face cover of the waste paper box from the
inner upper cover.
4
2
2) Remove two screws, and then remove the inner upper cover.
x2
F-4-3 F-4-3
4
4) Using a flat-blade screwdriver or the like, remove the rear middle
cover of the finisher.
F-4-5 F-4-5
F-4-4 F-4-4
F-4-6 F-4-6
4-3
4-3