Service Features; Caller Id Display; Direct Inward Dialing (Did); E.164 "+" Addition/Deletion - NEC UNIVERGE NEAX 2000 IPS System Manual

SERVICE FEATURES

The following is the features to be provided via SIP trunk for IP phone service.
Alternate Routing

Caller ID Display

Direct Inward Dialing (DID)

E.164 "+" Addition/Deletion

Fault Registration

Fragmented IP Packet Receiving
Multiple CODEC Selection
Session Timer
Listed from next page are the service features provided by NEAX 2000 IPS. According to that some of
these service features are not available depending on the terminal, set the service features based on the list.
For the further information, refer to the IPS System Manual and Feature Programming Manual.
Please note that the manuals above are not covered about the following.
Terminating System (translation method of called number)
(a) Terminated via Tie line
PBX defines the termination destination with Dial Number Development assuming that the
called number was originated from Tie line.
- Station/Attendant Console/trunk (at tandem connection) can be specified as a destination.
- When PBX defines to send to station, the last 1 to 8 digits of the number can be handled as the
station number.
- When PBX defines to send to trunk, the number can be deleted/added with LCR number de-
velopment. (Delete: Maximum 10 digits/Add: Maximum 32 digits)
(b) Terminated via DID
- The last 1 to 8 digits of the called number is handled as the DID number.
- The number can be converted into the following Terminating System with DID Number
Development.
• Station
• TAS
• Automated Attendant
• DISA
- Maximum 1000 DID numbers can be handled.
- DID number which is not registered is treated as Tie Line termination.
CHAPTER 1 GENERAL INFORMATION
NOTE
– 8 –
SERVICE FEATURES
NWA-011436-001 Rev.3.0
9ych1001.fm