Advertisement
STEP 3
STEP 3
STEP 3
#6
CABINET
DO NOT HOLD THE LEGS
HOLD TABLE
STEP 3
.
Attach two Leg End Panels (#6) and two Leg Side Panels (#7) between two Legs using four Bolts (#49) with four
washer (#50) per Leg End Panel and Side Panel.
.
Attach four Leg Insede Panels (#5) to the Leg assemblies using six Screws (#52) per Leg Inside Panel.See Step,3A.
.
Screw four Leg Levelers (#18) into the four Legs.See Step,3.
.
You will need 4 or more adults for this step.Carefully lift the assembly off the floor and turn it over.
CAUTION: Make sure that you place the table squarely onto its legs or damage to the table may occur.
.
Peel the backing off 40 Felt Pad and attach to 39 Pusher as shown in Step,3B.
#18
#50
#49
#7
DO NOT LEAN THE
TABLE ON ITS LEGS
STEP 3A
STEP 3A
#40
#40
NOTE: A3 Felt Pads may already be
attached to A1 Strikers.
#52
STEP 3B
STEP 3B
#39
Advertisement
