Summary of Contents for Dell PowerEdge XR Series
- Page 1 Dell PowerEdge XR-Series Heater Cabling Instructions Regulatory Model: HM001 Regulatory Type: HM001 December 2022 Rev. A00...
- Page 2 A WARNING indicates a potential for property damage, personal injury, or death. © 2022 Dell Inc. or its subsidiaries. All rights reserved. Dell Technologies, Dell, and other trademarks are trademarks of Dell Inc. or its subsidiaries. Other trademarks may be trademarks of their respective owners.
-
Page 3: Table Of Contents
Contents Chapter 1: Overview........................4 1. Assembling and connecting the safety ground wire for DC power supply and PowerEdge XR- series heater..................................5 2. Assembling the power supply input plug to the heater power cable ..............6 3. Assembling the DC input power cable for PowerEdge XR-series heater............7 4. -
Page 4: Chapter 1: Overview
3. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product. -
Page 5: Assembling And Connecting The Safety Ground Wire For Dc Power Supply And Poweredge Xr-Series Heater
○ One UL 1015 10 AWG, 2-meter maximum (105/30 stranded) US NEC red (European IEC brown) wire (V DC return) ○ Two UL 1015 10 AWG, 2-meter maximum (105/30 stranded) US NEC green/yellow, green with a yellow strip (European IEC green with a yellow strip) wire (safety ground) ●... -
Page 6: Assembling The Power Supply Input Plug To The Heater Power Cable
Figure 2. Safety ground pin connection for PowerEdge XR-series heater 1. Green/Yellow safety ground wire 2. Grounding post/stud 3. Locking/star washer 4. Spring washer 5. M4 Nut 2. Assembling the power supply input plug to the heater power cable To connect the power supply input plug to the heater power cable, perform the following steps: Steps 1. -
Page 7: Assembling The Dc Input Power Cable For Poweredge Xr-Series Heater
7. 10 AWG red wire 8. 10 AWG black wire 3. Assembling the DC input power cable for PowerEdge XR-series heater To construct the DC input power cable for the heater, perform the following steps: Steps 1. Strip the insulation from the ends of the DC power wires exposing approximately 0.394 - 0.433 inches (10 - 11 mm) of copper wire. - Page 8 2. Slide the PowerEdge XR-series heater into the PSU bay 1 (left bay) until the release latch snaps into place. CAUTION: The PowerEdge XR-series heater must be installed in PSU bay 1 (left bay). ® 3. Insert the heater input plug into the heater connector and press the input plug until it clicks in place. Use a VELCRO strap to loop the cable to the PowerEdge XR-series heater handle.
- Page 9 Overview...