Chapter 1 Setup Procedure For Emulex Converged Network Adapter Cards; Workflow - Fujitsu ETERNUS DX Configuration Manual

Server connection, fcoe for linux driver settings for converged network adapter cards

Hide thumbs Also See for ETERNUS DX:

Table of Contents

Chapter 1

Setup Procedure for Emulex Converged Network

Adapter Cards

This chapter describes the workflow required to establish a connection between a server with Emulex Con-

verged Network Adapter cards and an ETERNUS DX.

1.1

All work after this point requires "root" privileges.

When using Linux supported Converged Network Adapter cards, this procedure is used for all OS architectures

(e.g. x86, Intel64), Converged Network Adapter cards, and driver versions.

Workflow

Setting Up the Converged Network Adapter Cards

Install the Converged Network Adapter cards, acquire their physical addresses and WWN information.

"1.2 Setting Up the Converged Network Adapter Cards" (page 6)

•

Setting Up the Driver Parameters

Set the driver parameters by editing the configuration file.

•

"1.4 Setting Up the Driver Parameters" (page 8)

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (FCoE) for Linux

P3AM-6402-11ENZ0

Table of Contents