ACC-CX3RDK-CU5640 Getting Started Manual 28-Apr-2014 ACC-CX3RDK-CU5640 1 Revision History Date Major Changes Author 28–April –2014 Initial Draft Hardware Team www.e-consystems.com | Subject to change without notice Page 3 of 9...
Lens camera module based on OV5640 CMOS sensor from Omnivision. This camera daughter board can be directly interfaced to the Denebola - CX3 RDK board from e-con Systems. This document describes how to interface the ACC-CX3RDK-CU5640 Board on Denebola - CX3 RDK board and how to use the same.
Page 5
ACC-CX3RDK-CU5640 Getting Started Manual 28-Apr-2014 Signal Name Pin type Description w.r.t camera MIPI_DAT1+ MIPI Data Lane 1 Differential Pair + Do not connect MIPI_DAT1- MIPI Data Lane 1 Differential Pair - Do not connect RESERVED Do not connect Do not connect...
28-Apr-2014 7 ACC-CX3RDK-CU5640 Board handling procedure The ACC-CX3RDK-CU5640 Board should be mounted to Camera header (CN10) of the DENEBOLA_CX3_RDK Baseboard as indicated in the following steps 1. Top and bottom view of camera board are shown in the images below.
Page 8
Since the camera board connector is polarized, you can mount it on only one side as shown in the image. Figure 5: Camera Header Location Figure 6: ACC-CX3RDK-CU5640 Board insertion www.e-consystems.com | Subject to change without notice...
ACC-CX3RDK-CU5640 Getting Started Manual 28-Apr-2014 3. Power up the DENEBOLA_CX3_RDK Baseboard (Refer the DENEBOLA_CX3_RDK hardware user manual). After powering ON the DENEBOLA_CX3_RDK Baseboard, the Green color LED on Baseboard will glow as shown in the image below. This serves as an indication for power-up of Baseboard.