Example #2: Show Sntp Client; Example #3: Show Sntp Server; Example #4: Configure Sntp - NETGEAR ProSafe GSM7328 Administration Manual

NETGEAR 7000 Series Managed Switch Administration Guide

Example #2: show sntp client

(Netgear Switch Routing) #show sntp client
Client Supported Modes:
SNTP Version:
Port:
Client Mode:
Unicast Poll Interval:
Poll Timeout (seconds):
Poll Retry:

Example #3: show sntp server

(Netgear Switch Routing) #show sntp server
Server IP Address:
Server Type:
Server Stratum:
Server Reference Id:
Server Mode:
Server Maximum Entries:
Server Current Entries:
SNTP Servers
------------
IP Address:
Address Type:
Priority:
Version:
Port:
Last Update Time:
Last Attempt Time:
Last Update Status:
Total Unicast Requests:
Failed Unicast Requests:

Example #4: Configure SNTP

Netgear switches do not have a built-in real-time clock. However, it is possible to use SNTP to get
the time from a public SNTP/NTP server over the Internet. You may need permission from those
public time servers. The following steps configure SNTP on the switch:
16-2
unicast broadcast
4
123
unicast
6
5
1
81.169.155.234
ipv4
3
NTP Srv: 212.186.110.32
Server
3
1
81.169.155.234
IPV4
1
4
123
MAY 18 04:59:13 2005
MAY 18 11:59:33 2005
Other
1111
361
v1.1, May 2006
Simple Network Time Protocol (SNTP)