Table of Contents
Advertisement
SERVICE POSITION
As for this model, the bottom of rear cover is installed between the stand assy and the panel.
Therefore according to the following procedure when performing adjustment and operation check after the part replacement.
<KD-50X690E>
1. Remove all screws on the Stand
to main unit (6 screws)
KD-50X690E
2. Remove all screws on the Rear Cover to
Bezel & Main Board & Bracket (24 screws)
Attention:
the main unit after removing back cover and assembling the stand. But
considering mechanical design of the models and normal service
process,
status for repairing/testing at repair
avoiding possible scratch/deformation occurred.
Note:
will cause the stand with main unit fit closely, scratch or deformation
may occurred easily on the stand or bezel deco.
3. After removing rear cover , lie down the main unit
to a surface for following test repair.
4-734-425-01
4-595-215-01
4-595-223-01
4-595-221-01
4-595-213-01
4-595-219-01
This photo is based on Sony criteria for appearing standing
it is not recommended to keep main unit standing by this
Remove rear cover, then assemble the stand to main unit. This
SCREW M4x12
SCREW M3x6
SCREW M6x22
SCREW T3x8
SCREW M3x6
SCREW T3x8
center.
Please pay attention for
9
Advertisement
Table of Contents
