Table of Contents
Advertisement
2.4
Hardware Installation
This section details the steps needed to install various hardware components for the
UP Xtreme i12 Edge. It is recommended that you read through each step before
beginning installation and to make sure you have all necessary tools and components.
2.4.1
Wi-Fi Module (M.2 2230 E-Key Slot) Installation
Step 1: Remove the six (6) screws on the bottom plate.
Step 2: Remove the metal cover on the ANT Wi-Fi/BT antenna holes (2 holes on the
left and right sides of the system).
Chapter 2 – Hardware Information
31
Advertisement
Table of Contents
