Download Print this page
Panasonic ET-LAB80 Replacement Instructions
Panasonic ET-LAB80 Replacement Instructions

Panasonic ET-LAB80 Replacement Instructions

Lamp unit for lcd projector

Advertisement

Quick Links

Read these instructions completely before replacement.
Information for Users on Collection and Disposal of Old Equipment and
used Batteries
These symbols on the products, packaging, and/or accompanying
documents mean that used electrical and electronic products and
batteries should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and
used batteries, please take them to applicable collection points,
in accordance with your national legislation and the Directives
2002/96/EC and 2006/66/EC.
By disposing of these products and batteries correctly, you
will help to save valuable resources and prevent any potential
negative effects on human health and the environment which
could otherwise arise from inappropriate waste handling.
For more information about collection and recycling of old products
and batteries, please contact your local municipality, your waste
disposal service or the point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in
accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please
contact your dealer or supplier for further information.
[Information on Disposal in other Countries outside the European Union]
These symbols are only valid in the European Union. If you wish
to discard these items, please contact your local authorities or
dealer and ask for the correct method of disposal.
Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical
symbol. In this case it complies with the requirement set by the
Directive for the chemical involved.
Replacement Instructions
Lamp unit for LCD Projector
ET-LAB80
Model No.
R
TQZJ139-3

Advertisement

loading

Summary of Contents for Panasonic ET-LAB80

  • Page 1 Replacement Instructions Lamp unit for LCD Projector ET-LAB80 Model No. Read these instructions completely before replacement. Information for Users on Collection and Disposal of Old Equipment and used Batteries These symbols on the products, packaging, and/or accompanying documents mean that used electrical and electronic products and batteries should not be mixed with general household waste.
  • Page 2 Precautions with regard to safety Warning The lamp unit should only be replaced by a qualified technician. When replacing the lamp, allow it to cool for at least one hour before handling it. ● The lamp cover gets very hot, and contact with it can cause burns. Notes on replacing the lamp unit ●...
  • Page 3 Lamp unit replacement procedure Check that the area around the lamp unit has cooled down. Use a Phillips screwdriver to loosen the two lamp unit cover fixing screws at the rear of the projector until they turn freely, and then remove the lamp unit cover.
  • Page 4 Replace the air filter with the new filter which is supplied as an accessory, while referring to the replacement procedure which appears in the Operating Instructions for the LCD projector. Accessory • Air filter: 1 Web Site : https://panasonic.net/cns/projector/ Printed in Japan...