Adjusting Work Stop; Changing Blade Speed - Grizzly G0561 Owner's Manual

8. Use vise handwheel to tighten vise against
workpiece (see Figure 47).
Vise Handwheel
Figure 47. Location of vise handwheel.

Adjusting Work Stop

The Model G0561 is equipped with a work stop for
repetitive cutting operations. This stop will need
to be adjusted any time it is removed or reposi-
tioned, or anytime you change the cutting length.
To adjust work stop:
1. DISCONNECT MACHINE FROM POWER!
2. Measure and mark workpiece for cut.
3. Clamp workpiece in vise and adjust to desired
angle, aligning cutting line with cut mark.
4. Loosen thumb screw shown in Figure 48 and
adjust work stop until it contacts workpiece.
Tighten thumb screw to secure work stop.
Work Stop
Figure 48. Location of work stop and thumb
screw.
Model G0561 (Mfd. Since 01/18)
The Model G0561 is capable of blade speeds of
90, 135, 195, and 255 FPM (Feet Per Minute). To
adjust the speed, position the V-belt on the pulleys
that will provide your desired speed setting.
(Refer to Blade Speed Chart on Page 35 for
blade speed guidelines for various metals.)
Items Needed
Wrench or Socket
Replacement V-Belt (#P0561211) ...... As Needed
Open-End Wrench
To change blade speeds:
1.
2.
3.
4.
Thumb
Screw
Changing Blade
Speed
⁄ " ........................................ 1
1
2
⁄ " ....................................... 1
1
2
DISCONNECT MACHINE FROM POWER!
Determine blade speed for your cut (refer to
Blade Speed Chart on Page 35).
Open pulley cover.
Loosen hex bolts shown in Figure 49.
Figure 49. Location of motor mount hex bolts.
Qty
x 2
-33-