Advertisement
SPECIFICATIONS
Rim size
Tire size
Bolt hole PCD
Tire pressure
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
"do-it-yourselfers."
NOTE:
• This aluminum wheel is designed for use on the TPMS
(Tire Pressure Monitoring System) equipped vehicles.
• This aluminum wheel is equipped with the TPMS
sensor. See the Service Manual for tire replacement
procedure and TPMS sensor installation procedure.
• The illustrations of the aluminum wheels are shown for
reference purposes only.
• Install the correct size tire.
• Place the vehicle on a rack to remove and install the
wheels. Use a torque wrench to tighten the wheel nuts.
Torque the wheel nuts to: 108 N·m (80 lbf·ft).
• Use a tire changer to install and remove the tires from
the aluminum wheels as described in the Operation
Manual furnished with the tire changer. Do not use tire
levers to install and remove the tires on and from the
aluminum wheels as it may cause damage to the tire
and aluminum wheel.
• Be careful not to damage the wheel center cap when
installing the emblems.
• This center cap emblem kit should be installed only if
the ambient air temperature is 60°F (15°C) or above.
• To allow the adhesive to cure, do not wash the vehicle
for 24 hours.
2 of 9
19 x 8 J (offset 55)
245/40ZR19 98Y
114.3 (5 holes)
Front
250 kPa
(2.5 kgf/cm
2
, 36 psi)
Rear
250 kPa
(2.5 kgf/cm
, 36 psi)
2
1.
Using isopropyl alcohol on a shop towel, clean the
area where the center cap emblem will attach.
CENTER CAP
EMBLEM
WHEEL CENTER
CAP
CENTER CAP
EMBLEM
2.
Remove the adhesive backing from the center cap
emblem.
3.
Attach the center cap emblem to the wheel center
cap by aligning its pins with the holes in the wheel
center cap. After attaching, hold the emblem firmly
against the wheel center cap with the palm of your
hand for 30 seconds.
4.
Slide the push nuts onto the pins. Note the direction
of the push nuts.
AII 37562 (0709)
PUSH NUT
(Note the direction
of the push nuts.)
WHEEL
CENTER CAP
ADHESIVE
BACKING
© 2007 American Honda Motor Co., Inc. – All Rights Reserved.
PUSH
NUTS
6912030B
Advertisement
