Table of Contents
Advertisement
WARNING
Disconnect the electrical supply before performing maintenance to the Multi-surface Nozzle.
Failure to do so could result in electric shock or personal injury from vacuum cleaner
suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance problems. Any
service needed, other than those described in these Operating Instructions, should be
performed by an authorized service representative.
PROBLEM
Vacuum cleaner won't 1. Unplugged at wall outlet.
start.
Poor job of dirt
pick-up.
Multi-surface nozzle
will not run
when attached.
Vacuum Cleaner picks 1. Suction too strong.
up moveable rugs
-or- nozzle pushes
too hard
BEFORE REQUESTING SERVICE
Electric Shock or Personal Injury Hazard.
POSSIBLE CAUSE
2. Tripped circuit breaker/blown
fuse at household service
panel.
3. Loose hose electrical
connections.
1. Clogged airflow passages.
2. Worn multi-surface nozzle
brushes.
3. Worn or broken belt.
4. Dirty agitator or end caps.
1. Multi-surface nozzle
connections unplugged.
2. Worn or broken belt.
3. Dirty agitator or end caps.
1. Plug in firmly, push ON/OFF switch
to ON.
2. Reset circuit breaker or replace
fuse.
3. Reconnect hose ends.
1. Clear airflow passages.
2. Replace agitator (page 15-17).
3. Replace multi-surface nozzle.
4. Clean agitator and end caps.
(page 15-17)
1. Plug in firmly. (page 10)
2. Replace multi-surface nozzle.
3. Clean agitator and end caps.
(page 15-17)
1. Open suction control.
- 18 -
POSSIBLE SOLUTION
Advertisement
Table of Contents
