Installation; Remote Management Card Kit Contents; Pre-Installation Procedures - HP ProLiant DL140 G2 User Manual

Installation

In this section

Remote management card kit contents ........................................................................................................ 7

Pre-installation procedures ......................................................................................................................... 7

Installing the remote management card on ProLiant ML110 G3 servers........................................................... 8
Installing the remote management card on ProLiant ML150 G2 servers........................................................... 9
Post-installation procedures........................................................................................................................ 9
Remote management card kit contents
The remote management card kit is required only on ProLiant ML110 G3 and ProLiant ML150 G2 servers.
ProLiant ML110 G3
•
HP ProLiant ML110 G3 Remote Management Card
•
Spacer support
•
HP Lights-Out 100 Remote Management Card Installation Instructions for HP ProLiant ML110
Generation 3 Servers
ProLiant ML150 G2
•
HP ProLiant ML150 G2 Remote Management Card
•
Hexnut screw
•
HP Lights-Out 100 Remote Management Card Installation Instructions for HP ProLiant ML150
Generation 2 Servers
Pre-installation procedures
The installation procedures in this document are intended for individuals who are qualified in the servicing
of computer equipment and trained in recognizing hazards in products with hazardous energy levels.
WARNING:
serious damage to the equipment as well as bodily harm.
CAUTION:
management card.
IMPORTANT:
when installing the remote management card.
NOTE:
stable surface.
Back up the server data.
1.
Failure to properly turn off the server before you open the server may cause
Follow the ESD precautions listed in your server guide when handling the remote
Observe the pre- and post-configuration procedures described in later sections
The procedures described in this section assume that the server is positioned on a flat,
Installation 7