Table Of Contents; Safety Symbols; Safety Instructions - Bosch GTA570 Operating/Safety Instructions Manual

The definitions below describe the level of severity for each signal word.
Please read the manual and pay attention to these symbols.
Safety Symbols . . . . . . . . . . . . . . . . . . . . . . 2
Safety Instructions. . . . . . . . . . . . . . . . . . . . 2
Intended Use . . . . . . . . . . . . . . . . . . . . . . . . 3
Unpacking and Checking Contents . . . . . . . . 3
Tools Needed for Assembly . . . . . . . . . . . . . 3
Read all instructions. Fail-
ure to follow all instructions
listed below may result in serious personal in-
jury.
Fully assemble and tighten all the fasteners
required for this stand. Periodically check
that all fasteners are attached and adjusted
according to the assembly instructions in-
cluded in this manual. A loose stand is un-
stable and may shift in use and cause serious
injury.
Turn tool switch off and disconnect power
before mounting to the stand. Unintended
startup during assembly can cause injury.

Safety Symbols

This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this
symbol to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.

Table of Contents

Safety Instructions

SAVE THESE INSTRUCTIONS
Assembling the Stand . . . . . . . . . . . . . . . . . 4
Mounting the Saw to the Stand . . . . . . . . . . 4
Transporting the Stand . . . . . . . . . . . . . . . . 5
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . 5
Service. . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Before operating make sure the entire unit is
placed on a solid, flat, level surface. Serious
injury could occur if tool is unstable and tips.
Never stand on tool or its stand or use as lad-
der or scaffolding. Serious injury could occur
if the tool is tipped or the cutting tool is acci-
dentally contacted. Do not store materials on
or near the tool such that it is necessary to
stand on the tool or its stand to reach them.
Use only Bosch replacement parts. Any oth-
ers may create a hazard.
-2-