Toro Grandstand 139-1529 Installation Instructions

Bagger Enhacement Kit
Grandstand
Model No. 139-1529
Note:
In most mowing conditions, use standard high lift cutting blades while bagging leaves with this kit. In
dry, dusty conditions, use medium lift or low lift cutting blades while bagging leaves to prevent excessive
blowout of debris.
Contact your Authorized Service Dealer for the proper blades for different mowing conditions.. Refer to the
Operator's Manual for the correct procedure to replace the blades.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Left rubber baffle
Right rubber baffle
Left skid skirt
Right skid skirt
Carriage bolt (5/16 x 1 inch)
Locknut (5/16 inch)
Carriage bolt (5/16 x 1-1/4 inches)
Locknut (1/4 inch)
Hex-head bolt (1/4 x 3/4 inch)
Flat-head bolt (1/4 x 3/4 inch)
Preparing the Machine
1. Disengage the PTO, move the motion-control levers to the N
parking brake.
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving the operating
position.
3. Repair all bent or damaged areas of mower deck and replace any missing parts.
4. Clean the machine of any debris on the deck to ease installation.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® Mower
Qty.
–
Prepare the machine.
1
1
1
1
12
Install the baffles.
13
1
1
1
1
Register at www.Toro.com.
Form No. 3426-840 Rev B
Installation Instructions
Use
- position, and engage the
EUTRAL LOCK
Original Instructions (EN) All Rights Reserved *3426-840* B
Printed in the USA.