How To Access Service Mode - Samsung PS42D51SX/XEC Service Manual

Alignment & Adjustment

3-2 How to Access Service Mode

■ Using the Customer Remote
1. Turn the power off and set to stand-by mode.
2. Press the remote buttons in this order; POWER OFF-MUTE-1-8-2- POWER ON to turn the set on.
3. The set turns on and enters service mode.
4. Press the Power button to exit and store data in memory.
※ If you fail to enter service mode, repeat steps 1 and 2 above.
5. Initial SERVICE MODE DISPLAY State
Factory AIR 10
White Balance
uPD64083
ADV7402 Main
SDP51
MST9883
ADV7402 Sub
DNIe
Logic
PW318
Option
PW318 Upgrade
TL945 Upgrade
Reset
Release Date : XXX XX XXXX XX:XX:XX
Code No. : M1 Micom XX
PW318
TL945
※ The firmware version is subject to change without notice.
4. Buttons operations within Service Mode
MENU Full Menu Display / Move to Parent Menu
Item Selection by Moving the Cursor
Direction keys ▲ / ▼
Data Increase/Decrease for the Selected Item
Direction keys ◀ / ▶
Source Cycles through the active input source that are connected to the unit
3-2
T_XXXXXXXXX-XXXX
0.XX
Current input mode
Firmware version
Samsung Electronics