Summary of Contents for Days BE05W
- Page 1 B AT H S E AT ASSEMBLY and OPERATING MANUAL B a t h BE05W and BE06W Doc.-No.: E1-04-043-001...
-
Page 3: Table Of Contents
Bath seat Introduction The following manual provides descriptions relating to the assembly, operation and care of the B and B bath seats. Photographs of the B bath seat with backrest are used to demonstrate the assembly. You will find written notices regarding differences in operation and assembly for the B bath seat. -
Page 4: Safety Instructions
You will also find information about dealing with the product under this symbol. Use in accordance with the requirements The Days Healthcare bath seats offer individuals with restricted mobility but still sufficient sitting capacity the option to carry out daily personal hygiene in the bath tub. -
Page 5: Safety - General Notes
• The bath seats are not intended for use during examinations or treatments. • Use the bath seats only in technically perfect condition. • Use only spare parts and accessories released by Days Healthcare. • Do not carry out structural changes which are not approved by the manufacturer. -
Page 6: Notes On The Assembly Of The Bath Seats
• Carry out the work only if you are familiar with using the tools employed. 2.0 Extent of delivery / component name The BE05W and BE06W bath seats are packed in cartons. Use the following list to check the contents of the package before starting the assembly. -
Page 7: Assembly
Bath seat Assembly 3.0 Assembly Preparations Observe the safety notes in chapter 1.3 ➨ Prepare all fastening screws as follows: Allen screw with Prepare fastening screws plastic disk, NOTE Take care that the moulded edge (a) of the plastic disk (7) points to the screw head (see detail photo). - Page 8 Bath seat Assembly Only for bath seat with backrest: Attach bachrest ➨ Push washer with deep turned groove (3) onto the upper fastening screw and screw down backrest (4). NOTE For easier assembly, first screw in all fastening screws loosely up to the stop and do not tighten.
- Page 9 Bath seat Assembly ➨ Push washer with deep turned groove Screw down side panel onto the tubes of the already screwed down seat frame (8). ➨ Screw the side panel to the seat frame and the backrest. Tighten fastening screws and attach masking cap ➨...
-
Page 10: Attaching The Bath Seat To The Tub
Bath seat Attaching the bath seat Attaching the bath seat to the tub Only use the bath seat in bath tubs for which the secure support of the rubber caps (1) is guaranteed. At least 2/3 of the width (B) of all four rubber caps (1) has to be supported by the bath tub rim (2). -
Page 11: Cleaning And Disinfection
Small stains and dust is best removed with moist wipes. ➨ Larger stains can be removed by non-scouring, mild cleaning agents. Disinfection If disinfection is required during use, only agents according to the Days Healthcare skin protection and hygiene plan must be used. 6.0 Maintenance / Spare parts Maintenance The shower chair is maintenance-free, however, should be checked on a monthly basis. -
Page 12: Reuse
Distance seat to bath tub rim ........ 20.5 cm *Dimensions of the assembled shower chair, minimal differences possible. 11.0 Warranty Days Healthcare offers a 24 months warranty on perfect quality within the framework of its general terms and conditions. Issued: 08.08.2013... - Page 14 Dealers Stamp Days Healthcare A Trading Division of Patterson Medical Ltd North Road Bridgend Ind Est Bridgend CF31 3TP Tel 01656 664700 Fax 01656 664750 E-Mail info@dayshealthcare.com www.dayshealthcare.com...