Advertisement
Quick Links
Download this manual
See also:
User Manual
Read this before you start...
Proper installation is the responsibility of the purchaser.
SERVICE CALLS PERFORMED AS A RESULT OF POOR INSTALLATION ARE THE
RESPONSIBILITY OF THE INSTALLER.
Make sure you have everything necessary for proper installation.
2
1
GROUNDED ELECTRICAL OUTLETS are required. See Electrical Requirements.
2
STANDPIPE DRAIN SYSTEM must be able to accept 1-1/2 inch O.D. drain hose.
Standpipe height of 36 inches is recommended. The drain must permit 23 gallon per
minute flow to evacuate the washer.
NOTE: If the standpipe height is less than 3 feet or greater than 5 feet, refer to the
"DRAIN FACILITY" section to determine if special provisions are needed.
3
HOT AND COLD WATER FAUCETS must be within 4 feet of the back of the washer.
NOTE: For installations requiring longer hose length, it is recommended to purchase a
double male 3/4" NH coupling and Maytag hose #33-7046 or equivalent.
4
WATER HEATER set to deliver 140°F (60°C) hot water to the washer.
5
PROTECTION FROM WEATHER: Do not store or operate washer below 60°F (15°C).
PARTS supplied for installation:
Cable tie to secure drain hose to standpipe, inlet hose or laundry tub
2 washers and 2 screens for water hoses
1
3
TOOLS needed for installation:
• Cutting knife
• Channel lock
• Nut driver
• Level
• Crescent wrench
4
Advertisement
Related Manuals for Maytag MAV9504EW
Summary of Contents for Maytag MAV9504EW
- Page 1 NOTE: If the standpipe height is less than 3 feet or greater than 5 feet, refer to the “DRAIN FACILITY” section to determine if special provisions are needed. HOT AND COLD WATER FAUCETS must be within 4 feet of the back of the washer. NOTE: For installations requiring longer hose length, it is recommended to purchase a double male 3/4”...
- Page 2 (Part No. 12001875) containing accessory ground wire, clamp, ground screw and washer can be purchased. Contact your authorized Maytag dealer for further assistance. Follow ALL grounding requirements and codes. A proper external ground MUST be determined prior to wire hookup. Consult local building officials and a qualified electrician if in doubt.
- Page 3 (Part No. 12001585). If a high- volume pump is purchased, the extension kit is included. Contact your authorized Maytag dealer for further assistance. FLOORING For best performance, the washer must be installed on a solidly constructed floor.
- Page 4 NOTE: Retain the corner posts for later use. • Untape and raise the washer lid. R e m ove the s t y r o foam tub bl o ck, remove the items shipped in the spin basket, then replace the tub bl o ck .
- Page 5 With hands on opposite corners, rock the washer to check for stability. With a level, check the washer and make the n e c e s s a ry adjustments to the front leveling legs. N OT E :Self-stabilizing rear legs level the rear of the machine side-to-side.
- Page 6 Water has been turned on. Check for leaks at faucets and water valve connections. Drain hose is properly located into drain facility and is not twisted or kinked. Washer has been leveled with legs firmly on the floor. The front leveling legs’ locking nuts have been tightened.