Part Names; Projector - Hitachi CP-AW100N User Manual

Part names

Part names

Projector

(1) Lamp cover (69)
The lamp unit is inside.
(2) Focus ring (23)
(3) Control panel (5)
(4) Elevator buttons (x 2) (17)
(5) Elevator feet (x 2) (17)
(6) Remote sensors (15)
(7) Lens (74)
(8) Intake vents
(9) Filter cover (72)
The air filter and intake vent are
inside.
(10) Speaker (42)
(11) Exhaust vent
(12) AC IN (AC inlet) (18)
(13) Rear panel (5)
(14) Security bar (13)
(15) Security slot (13)
(16) Lens door (74)
(17) Battery cover (73)
(18) Mirror (74)
WARNING
vent during use or just after use, since it is too hot.
►Be careful not to pinch your finger with the lens door, to prevent an injury.
►Never look into the projection lens or mirror while the projection lamp lights,
since the projection lamp ray may cause a trouble on your eyes.
►Do not handle the elevator buttons without holding the projector, since the
projector may drop down.
CAUTION
heating up. Do not cover, block or plug up the vents. Do not place anything that
can stick or be sucked to the vents, around the intake vents. Clean the air filter
periodically.
►Do not use the security bar and slot to prevent the projector from falling down,
since it is not designed for it.
4
►HOT! : Do not touch around the lamp cover and the exhaust
►Maintain normal ventilation to prevent the projector from
(1)
(6)
(7)
(2)
(3)
(15) (13)
(14)
(17)
(8)
HOT!
(4)
(5)
(11)
(9)
(10)
(18)
(16)
(12)
HOT!