Auto Gradation Adjustment; Operation When Moving The Host Machine; Checking The Connection To The Network; Setting Up The Network - Canon iR C1020 Series Service Manual

Chapter 2

2.2.8 Auto Gradation Adjustment

1) Open the feeder.
2) Clean the copyboard glass of the host machine.
3) Set A4 or LTR paper on the cassette. (Refer to the cassette settings.)
4) Close the feeder.
5) Specify the full adjustment in additional function mode.
[Additional Func] > [Adjustment/Cleaning] > [Auto Gradation Correction] > [Full Correction]
6) When 'Test Print1' is displayed, press [OK].
Test Print 1 is output. (It takes approx, 3min.)
7) Follow the instruction on a control panel and set the test print 1 on the copyboard glass.
8) Close the feeder.
9) Press [OK].
Test Print 1 is read.
10) When 'Test Print 2' is displayed, press [OK].
Test Print 2 is displayed.
11) Follow the instruction on a control panel and set the test print 2 on the copyboard glass.
12) Close the feeder.
13) Press [OK].
Test Print 2 is read.
14) When the auto adjustment window is displayed, remove the test print 2 from the copyboard glass.
15) Exit [Additional Func].

2.2.9 Operation when moving the host machine

If moving the host machine to another location by a truck etc. after installation for some reasons, follow the procedure below.

2.3 Checking the Connection to the Network

2.3.1 Setting Up the Network

1) Turn OFF the main power switch.
2) Connect the network cable with the host machine to turn ON the main power switch.
3) Inform the system administrator at the installation site that the host machine installation is complete and request the network settings of the host machine.
4) When the network settings are complete, turn OFF and then ON the main power to enable the settings.

2.3.2 Procedure for Ping Operation

1) Select the PING command in additional function mode.
[Additional Func] > [System Management] > [Network Settings] > [TCP/IP Settings] > [IPv4 Settings] > [PING Command]
2) Using the control panel keypad, enter the PING command and press [OK].
Enter the IP address of the connected PC in PING command.
The message to indicate presence/absence of reply from the host is displayed.
2-6
Make sure to set a test print correctly. If a test print cannot be read correctly,
the adjustments of gradation, density and color cannot be performed
appropriately.
Points to note when moving the host machine
Be careful not to push the host machine hard. It may fall down
(especially, on the carpeted floor).
Perform this item only when connecting to the network.
Make the following setting only in the case of a user network environment
is TCP/IP.
MEMO:
Check to see that the Ping setting is normally made with the Ping function.
0019-0673
0019-0700
0019-0679
0019-0680