Makita G1100 User Manual page 14

G1100(US)_GU1835 2004.2.6 1:04 PM ページ8
(e) After 20 to 30 seconds of warm-up is completed, turn the engine switch to "
(f) Make sure the output lamp is on. This indicates that the generator is properly operating.
NOTE
Please consult with the Makita factory or authorized service center if the output
lamp is turned off during the proper operation.
2. USING ELECTRIC POWER
Make sure that the appliance is switched OFF before connecting it to the generator.
■ ■
US
Do not move the generator while it is running.
■ ■
GB
Be sure to ground the generator if the connected appliance is grounded. Failure to
■ ■
GB
ground unit may lead to electrical shock.
GB
CONTROL PANEL
GB
G1100 (60Hz-120V)
GB
GB 1
GB
GB
GB
GB
GB
GB
GB
GB
GB
8
(1) AC APPLICATION (See Fig. 4 4 -r r )
(a) Make sure the output lamp is turned on.
(b) Turn off the switch(es) of the electrical appliance(s) before connecting to the generator.
(c) Insert the plug(s) of the electrical appliance(s) into the receptacle. (See Fig. 4-r)
Check the amperage of the receptacles
■ ■
used referring to TABLE 1, and be
sure not to take a current exceeding
the specified amperage.
Be sure that the total wattage of all
■ ■
appliances dose not exceed the rated
output of the generator.
8
WARNING
2
3
4
5
6
7
Style
" (RUN) position. (See Fig. 4-e)
q OUTPUT LAMP
w OIL SENSOR LAMP
e AC RECEPTACLES
r AC CIRCUIT BREAKER
t DC TERMINALS
y DC CIRCUIT BREAKER
u GROUND TERMINAL
i ENGINE SWITCH
Ampere Receptacle AC plug
NEMA NEMA
Up to 20A
5-20R 5-20R
TABLE 1
Description
GFCI (Ground Fault
Circuit Interrupter)
Receptacle, duplex