Maintenance - Makita AT1150A Instruction Manual

Direction of exhaust air
The direction of exhaust air can be changed 360 degrees
of angle by turning the exhaust cover with a hand.
Removing jammed staples
WARNING:
• Always disconnect the hose before removing sta-
plers.
Remove the staples from the magazine.
Lift up the latch on the top of driver guide by hand.
1
If the latch cannot be lift up by hand, insert a slotted bit
screwdriver in the gap between the latch and the door
and force it up.
Open the door and take out staples.
1
007207
1. Exhaust cover
1
007203
1. Driver guide
2
2. Latch
007204
1. Slotted bit
1
screwdriver
2
2. Latch
3
3. Door
007205
1. Door
Place the latch spring on two hooks of the driver guide
and return it to its original position by pressing it.
1
CAUTION:
• If the tip of staple driver has worn, staple jamming
and shallow driving will tend to occur. When this
occurs, have it repaired by Makita Authorized or
Factory Service Centers.

MAINTENANCE

CAUTION:
• Always disconnect the air hose from the tool before
attempting to perform inspection or maintenance.
Maintenance of stapler
Always check the tool for its overall condition and loose
screws before operation. Tighten as required.
With tool disconnected, make daily inspection to assure
free movement of the contact element and trigger. Do not
use tool if the contact element or trigger sticks or binds.
When the tool is not to be used for an extended period of
time, lubricate the tool using pneumatic tool oil and store
the tool in a safe place. Avoid exposure to direct sunlight
and/or humid or hot environment.
7
007206
1. Driver guide
2. Latch
2
007313
007310