Adjusting Belt Tracking - Makita 9404 Instruction Manual

ASSEMBLY
1. Lever
more than 6mm (1/4")
1. Steel plate
2. Adjusting knob
2
1. Dust bag
2. Dust spout
8
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing abrasive belt
003501
1
Pull the lever all the way out and install the belt over the roll-
ers, then return the lever to the original position.
003376
CAUTION:
• When installing the belt, make sure that the direction of
the arrow on the back of the belt corresponds to the one
on the tool itself.

Adjusting belt tracking

003380
1
Switch on the tool and make sure that the belt is aligned
properly. If the edge of the belt extends beyond the edge of
the base or the edge of the belt retracts more than 6 mm
(1/4") away from the edge of the base, use the adjusting
knob to adjust the belt tracking.
2
Dust bag
003385
Attach the dust bag onto the dust spout. The dust spout is
1
tapered. When attaching the dust bag, push it onto the dust
spout firmly as far as it will go to prevent it from coming off
during operation.