Panasonic BP-5917C40 Technical Handbook page 28

SOLAR CELL-POWERED WARNING LIGHTS - CONTINUED
8.4 Standard specifications
Solar cell output
Ni-Cd batteries ratings
LED axial light intensity
Flashing cycle
Duty ratio
Peak current
Operation start illuminance
Operating temperature range
Unit dimensions
Weight
Compatible pole diameter
Color of unit casing
8.5. Installation/operating precautions
Before securing the warning light, set the switch at
•
the back of the unit to ON, and adhere the accessory
seal to the groove provided for the switch.
Bear in mind that the amount of power generated
•
will be significantly reduced if a tree or structure is
situated to the south and in proximity to where the
unit is installed.
8.6. Dimensions (mm)
(Front view)
Panasonic
3.4V, 14.5 mA
2.4v, ll0mAh
7,000 mcd
6,000 mcd
1 sec.
1.6%
37 mA
30 to 300 lux, outdoor light
-l0°C to +50°C
58(W)x116(H)x(55(D) mm
l30g (unit), approx. 30g (mounting clamp)
34 to 57 mm
59 to 82 mm
Black
Sunceram II cell
37
for outdoor use
Lightemitting area
30
58
(Unit: mm)
Solar Cells Handbook, Page 27
(average) (incident light AM 1.5,100 mW/cm
(5-hour rate)
(average) (red, 20 mA)
(average) (yellow, 20 mA)
(2.5v battery voltage)
(2.5v battery voltage)
(2.5v battery voltage)
(using standard clamp)
(using large-diameter clamp)
(standard; also available in white depending on
quantity ordered)
If the warning light has been in storage for a
•
prolonged period of time, recharge it adequately by
exposing it to direct sunlight before use.
Do not use the warning light for applications.
•
where an accident, etc. may be caused by the
unit's failure to light.
(Side view)
(Top view)
51
32
R10
Sunceram II cell for outdoor use
(Bottom view with clamp installed)
Clamp
2
)
August 1998