Steps
1. Insert the intrusion switch into its slot in the chassis.
2. Route the intruder cable through the routing guides on the system board.
3. Connect the intrusion-switch cable to the connector on the system board.
Next steps
1. Install the
air
shroud.
2. Install the
side
cover.
3. Follow the procedure in
Internal hard-drive cage
Removing the internal hard-drive cage
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
air
shroud.
4. Remove the
2.5-inch hard-drive
5. Remove the
3.5-inch hard-drive
About this task
The following images indicate the location of the internal hard-drive cage and provide a visual representation of the removal
procedure.
Steps
1. Disconnect the SATA power-cables and SATA data-cables from the connectors on the system board.
2. Remove the five (#6-32) screws from the hard-drive cage.
3. Slide and remove the hard-drive cage out of the computer.
After working inside your
Before working inside your
assembly.
assembly.
computer.
computer.
Removing and installing components
79