Assembly Instructions - Black & Decker BHOF04 Instruction Manual

SET UP & USE

ASSEMBLY INSTRUCTIONS

1. The base comes with 8 screws. Remove four of the screws. Take lower body and
use those four screws to attach to the base. Add the base cover.
a. The base comes with 8 screws.
2. Screw the middle body tube to the lower body tube by using 3-M5×6mm screws
and add the cord clip.
3. Insert the smallest tube into the upper body tube, and attach the upper body to
the middle body by using 3-M5x6mm screws. Then add the tube cover, and the last
cord clip. Pull the smallest tube up from inside the middle body. Loosen the tube
cover to adjust the small tube to increase and decrease the height of the heater.
Tighten the tube cover when optimal height is reached. 3-M5×6mm screws.
Smallest Tube
b. Remove four of the screws.
Cord Clip
Tube Cover
Upper Body
Cord Clip
Base Cover
c. Take lower body and use those
four screws to attach to the base.
Middle Body
Cord Clip
3-M5×6
Lower Body
Smallest Tube
Tube Cover
4-M6x30
Base
Cord Clip
Upper Body
Cord Clip
3-M5×6
Page 9