Download Print this page
Sealey RE2281 Instructions
Sealey RE2281 Instructions

Sealey RE2281 Instructions

Coil spring compres sorwishbone suspension 1000kg

Advertisement

Quick Links

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS
AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO
DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS
SAFE FOR FUTURE USE.
1.
SAFETY INSTRUCTIONS
DANGER! Stop compressing the spring before the coil
windings touch.
WARNING! Ensure Health & Safety, local authority,
and general workshop practice regulations are adhered
to when using this equipment.
Ensure that a vehicle which has been jacked up is
adequately suported with axle stands and that the
wheels are chocked,refer to the vehicle manufacturer's
service instructions or a proprietary manual.
WARNING! Wear approved safety eye protection
(standard spectacles are not adequate).
WARNING! Measure the outer diameter of the spring
to be compressed and select the correct set of yokes to
fit the spring.
DO NOT operate spring compressor if parts are
damaged or missing as this may cause failure and/or
personal injury.
DO NOT force the spring compressor to achieve a task
it is not designed to perform.
DO NOT allow untrained persons to use the spring
compressor.
Familiarise yourself with the applications, limitations
and potential hazards of the spring compressor.
Maintain the spring compressor in good condition.
Replace or repair damaged parts. Use genuine parts
only. Unauthorised parts may be dangerous and will
invalidate the warranty.
Keep the work area clean, uncluttered and ensure
there is adequate lighting.
Keep hands and body clear of the spring when
operating the spring compressor.
Maintain correct balance and footing. Ensure the floor is
not slippery and wear non-slip shoes.
Remove ill fitting clothes. Remove ties, watches, rings,
other loose jewellery. Contain and/or tie back long hair.
Wear appropriate protective clothing.
When not in use clean and store the spring compressor
in a safe, dry, childproof location.
2.
TECHNICAL SPECIFICATION
Model No: .......................................................RE2281
Contents: ...................................................Yokes (x4),
................................................................Force Screw,
....................................... 23 to 19mm Drive Extension
......................... 19mm Combination Ratchet Spanner
.............................................. 8mm T-Handle Hex Key
Capacity:..........................................................1000kg
Size/Suitability: ........................................Ø60-170mm
Jaw Opening: .............................................30-245mm
Drive: .................................................19 & 23mm Hex
3.
INTRODUCTION
Designed for use on wishbone suspension using access points
in the rear suspension arm. Features two pairs of carefully
shaped yokes that prevent the coil spring from bowing. Saves
time over traditional methods of demounting springs.
© Jack Sealey Limited
INSTRUCTIONS FOR
COIL SPRING COMPRESSOR-
WISHBONE SUSPENSION 1000KG
MODEL N
: RE2281
O
Fig.1
Item Description
1
Yoke 60-120mm Upper
2
Yoke 60-120mm Lower
3
Yoke 120-170mm Upper
4
Yoke 120-170mm Lower
5
Force Screw
6
Drive Extension
7
T-Handle Hex Key
8
Combination Ratchet Spanner
Fig.2
Original Language Version
Part No.
RE2281.01
RE2281.02
RE2281.03
RE2281.04
RE2281.05
RE2281.06
RE2281.07
RE2281.08
RE2281
Issue: 1 - 07/10/13

Advertisement

loading

Summary of Contents for Sealey RE2281

  • Page 1 MODEL N : RE2281 Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
  • Page 2 Before each use check the compressor to ensure it is not damaged or worn. If suspect, do not use the unit, but contact your local Sealey Dealer who will be able to advise you regarding repair kits and spare parts.