Assembling The Piston And Cylinder - Husqvarna 555 Workshop Manual

Faults and causes
Score marks on the piston (A)
1. Leakage, check not carried out.
2. Too low octane fuel.
3. Too low or incorrect oil in the fuel.
Carbon build-up (B)
1. Too much or incorrect oil in the fuel.
See igure 63.
Piston ring breakage
1. Piston ring worn out.
2. ersi ed piston ring groo e.

7.22 Assembling the piston and cylinder

1
il the gudgeon pin bearing with two-stroke oil and
insert it into the crank rod. See gure 64.
2
Replace the piston with the arrow facing the e -
haust port, and slide in the gudgeon pin and t the
circlips. NOTE! Use new circlips. See gure 64.
3
il the piston and piston ring with two-stroke oil.
4
Put a new cylinder base gasket in place. Compress
the piston ring and carefully push the piston into
the cylinder opening.
5
Attach the cylinder. The screws must be tightened
crosswise with a tightening torque of 8-10 Nm.
NOTE!
It is very important that the intake system is
sealed. Otherwise the engine may seize up.
A
ig 63
ig 64
ig 65
Repair nstructions
B
47
English -