Power On And Power Off The Camera Unit; Power On The Camera Unit; Power Off The Camera Unit - Panasonic AW-HE20KP Operating Instruction

Power on and Power Off the Camera Unit

Power on the Camera Unit

When performing the operations using the wireless remote control.
Set all the power switches of the units and devices connected in the system to ON.
When the power is supplied, the status display lamp lights orange.
After the initial setting is completed, it switches to green and the power turns on.
[Note]
During the initial settings operation, the unit cannot be operated.

The unit stores its STANDBY / POWER ON mode status in the memory.

If the power supply is cut off while the operation is in POWER ON mode, the operation will transfer to the POWER

ON mode the next time power is supplied.
When transferring to the STANDBY mode

- Status indicator LED: Orange
- The current pan-tilt position is stored in the memory (as a POWER ON preset), and the panning/tilting moves so
that the camera points in the backward-facing direction.
When transferring to the POWER ON mode

- Status indicator LED: Green (after the initial setting operation is completed)
- The pan/tilt position is moved to the position which was stored in the memory when the transition to the
STANDBY mode was made.
POWER ON preset

- The pan/tilt position return to the place just before entering STANDBY mode when returning from STANDBY
mode to POWER ON mode.
If the power is turned off without transferring to the STANDBY mode, the pan/tilt unit position will not be stored in the

memory or reflected in the POWER ON preset. The previous POWER ON preset will be applied.
When performing the operations using the controller
For details, refer to the operating instructions for the controller.

Power off the Camera Unit

When performing the operations using the wireless remote control
1. Press one of the [CAMERA 1] to [CAMERA 4] buttons on the wireless remote control to select the unit.
2. Press the [ON/STANDBY] button on the wireless remote control for 2 seconds.
The unit enters STANDBY mode.
3. The unit's status display lamp now lights up orange.
4. If a multiple number of units are used, repeat steps 1 and 2 as required.
5. Set all the power switches of the units and devices connected in the system to OFF.
When performing the operations using the controller
For details, refer to the operating instructions for the controller.
(AW-RP60/AW-RP150).
(AW-RP60/ AW-RP150).
36