Tracks - Installation Direction; Storage - Polaris PROSPECTOR PRO 2.0 User Manual

TRACKS - INSTALLATION DIRECTION

Front track: can be installed in both direction.
Figure 25.
Figure 25
Rear track: arrow molded on rear tracks must
point out, away from Track system frames. See
Figure 26.
Figure 26

STORAGE

CAUTION: Contaminants can alter and corrode the
moving parts of the Track System during storage.
It is strongly recommended to perform the
prescribed maintenance before storing the Track
System.
Before storing the Track System, it is important to
perform the recommended annual maintenance
tasks. Refer to the maintenance chart of page 18,
section Intervals - column 200 Hrs / Annual.
To avoid deterioration of mechanical components
due to potential prolonged exposition to water,
sand, salt or other similar contaminant, it is
necessary to perform the recommended tasks
contained in the maintenance schedule.
The following service steps must be performed
before storage:
• Clean Track system.
• Inspect Track system completely.
• Release track tension.
• Remove, clean and lubricate wheel seals.
• Lubricate hub seal.
• Verify and/or replace oil in hub.
• Verify torque on bolts.
For more details, refer to the Maintenance,
Lubrication, and Wear sections of this manual.
Store the System by laying down each frame on
its side, away from direct sunlight. Figure 27.
STORAGE
Figure 27
16