Honeywell ExiLED 290142 Quick Start Manual

Dimensional Drawings:
ExiLED 25m
266mm
Installation:
1
click click
4
The product contains bracket for wall mounting and spacers for ceiling mounting.
Step 1: For double sided pictogram, install the appropriate pictograms to both sides, push up
until you hear click sound. For single sided pictogram, there is one blind pictogram in
the package.
Step 2: Install the retaining clip to hold the pictograms.
Step 3: Dismantle the luminaire by sliding the mounting part as shown in picture. Fasten the
mounting part (with screws from within) to either wall bracket(supplied), ceiling (with
or without supplied spacers), pendulum, wire or flag bracket.
Step 4: Make a hole on a black grommet and pass the mains cables through it. Connect the
mains cables to the terminal blocks: L for live wire, N for neutral and PE for ground.
Power supply cables cross section should be 0.8 - 3 mm . Tighten the cable tie around
the cables.
Honeywell Life Safety AS, Postboks 236, 1372 Asker
CBS Emergency Light
53mm
2
click click
ExiLED
ExiLED 40m
366mm
3
2
http://www.hls-nordic.com
GB
53mm