Remove The Turbocharger - ABB HT564896 Operation Manual

7.2
7.2
CAUTION
© Copyright 2016 ABB. All rights reserved.
Removal and installation

Remove the turbocharger

Remove the turbocharger
A suitable suspension device (as illustrated) must be used when

removing and installing the turbocharger. The suspension device is not
supplied by ABB Turbo Systems.
Disconnect all gas, air and oil lines in accordance with engine builder's

instructions.
Oil orifice plates
An orifice plate for adjusting the oil pressure is fitted in each of the two
oil inlet channels in the bearing casing. When the cartridge group, the
bearing casing or the turbocharger is fitted to the engine, it must be
ensured that the orifice plates that are specified for the turbocharger
have been installed in the two oil inlet channels.
Check correct installation of oil orifice plates.

Suspension dimension
A
B
C
Use the two suspension lugs (L1, L2) on the bearing casing (observe the
marking on the insulation).
The two suspension lugs on the foot at the turbine end (T1, T2) serve to
align the turbocharger horizontally.
Operation Manual / TPL76-C
7
7.2
Distance in [mm]
860
1210
800
Page 86