DIMinBOX 2CH. Two channel universal DIMMING actuator for lighting control
ZDI-DB2C
FEATURES
Size: 80 x 90 x 60mm (4.5 DIN rail units).
2 Channel 310W (230VAC) or 160W (110VAC) for R L C loads
or 125W (230VAC) or 65W (110VAC) for dimmable CFL and
LED lamps @ 25ºC (50-60Hz).
Automatic detection of R L C load type.
Dimming pattern manual selection for CFL and LED lamps.
Optional dimming manual control.
2 analog/digital inputs.
KNX BCU integrated.
Independent control assembly, to be mounted in electrical
panels with DIN rails.
Total data saving when power failure occurs.
CE directive compliant.
1. Terminal block (neutral and
phase)
5. Analog/Digital inputs
Programming/test button: push the button to set the PROGRAMMING MODE. If this button is held while plugging the device into
the KNX bus, it goes into secure mode. If this button is held more than 3 seconds, the device goes into TEST MODE.
Programming LED: lighting red = programming mode; blinking red = safe mode; lighting green = test mode.
Output LED indicators: lighting during a press button with manual control enabled. Moreover, it indicates the error present in the
outputs. For further information, consult the "error notifications" section.
GENERAL SYSTEM FEATURES
Device type
KNX supply
External power supply
Max channel load
Min channel load rating
Device action type
Electrical solicitations period
Type of protection
Ambient temperature
Storage temperature
Ambient humidity
Storage humidity (relative)
Assembly
Power failure response
Operation indicator
Weight
PCB CTI index
Enclosure
© Zennio Avance y Tecnología S.L.
Technical Documentation
2. KNX bus
connection
6. Output LED
indicator
Electric operation control device
Voltage
29V DC SELV
Voltage range
21...31VDC
Consumption
192mW
Connection type
Typical bus connector TP1, 0,50 mm² section
110-230V 50-60Hz
R L C Loads: 310W (230VAC) or 160W (110VAC) @ 25ºC; CFL and
LED lamps 125W (230VAC) or 65W (110VAC) @ 25ºC (depending
on manufacturer and model)
5W R L C loads; 5W (230VAC) or 3W (110VAC) CFL and LED lamps
Type I
Long
IP 20, clean environment
-5 ºC to +45 ºC
-20 ºC to +70 ºC
30 to 85% RH (no condensation)
30 to 85% RH (no condensation)
Independent control assembly to be mounted inside distribution
boxes or electrical panels
Data saving
Programming LED (red) ON when pushing the programming button.
Test LED (green) ON when device is in Test mode
200 gr.
175 V
PC+ABS FR V0, halogen free
Draft Edition
4
3
2
1
3. Programming/Test LED
7. Manual Control push
button
Further information
www.zennio.com
DIMinBOX 2CH
Technical Documentation
5
8
Figure 1. DIMinBOX
4. Programming/Test push
button
8. Output channels
Page 1 / 4
6
7