Battery Installation; Belt Clip - Cobra HH 50 WX ST Operating Instructions Manual

Install the Batteries
To remove battery chamber cover, press down
1
on the arrow and slide down.
Install the batteries by polarity markings.
2
3
Replace cover.
NiMH rechargeable batteries
should be charged a minimum
of 12 hours with a CA-45CB
charger.
Attach the Belt Clip
Slide the belt clip up
1
on the rails of the
base until tab locks.
Press and
hold down
on arrow
and slide
down
To remove the belt
2
clip, lift the tab out
and slide the belt
clip down.
Operation

Battery Installation

Note
Ignoring polarity markings (+/-)
may cause damage to both the
unit and the batteries.
The HH 50 WX ST requires
9 "AA" alkaline or NiMH
batteries rated at 1000 mAh
(not included with
the unit).
When the batteries are low or
need charging the
icon will flash on the LCD dis-
play. Replace alkaline batteries
or recharge NiMH batteries.
NiMH rechargeable batteries
should be charged a minimum of
12 hours with a CA-45CB charger.
NiMH rechargeables should have
a rating of 1.2 vdc, 1000 mAh.
Attach the Belt Clip
3
BATTERY