Starter (Choke) Cable Freeplay Adjustment; Exhaust System Inspection - Yamaha MM600D Service Manual

STARTER (CHOKE) CABLE FREEPLAY ADJUSTMENT/

EXHAUST SYSTEM INSPECTION

STARTER (CHOKE) CABLE FREEPLAY
ADJUSTMENT
1. Measure:
•
SEJ2280
2. Adjust:
•
Adjustment steps:
•
Loosen the locknut 1.
•
Turn the adjusting nut 2 in or out until the
specified freeplay is obtained.
Turning in → Freeplay is increased.
Turning out → Freeplay is decreased.
•
Tighten the locknut.
EXHAUST SYSTEM INSPECTION
1. Open the shroud.
2. Remove:
•
3. Inspect:
•
•
•
•
•
•
4. Check:
•
SEJ2290
5. Install:
•
2-15
INSP
ADJ
Starter cable freeplay a
Out of specification → Adjust.
Starter cable freeplay a:
0.5 ~ 1.5 mm (0.02 ~ 0.06 in)
Starter cable freeplay
Springs
Refer to "EXHAUST ASSEMBLY" in CHAP-
TER 5.
Exhaust joint 1
Exhaust pipe 2
Exhaust silencer 3
Cracks/damage → Replace.
Exhaust gasket 4
Exhaust gasket 5
Exhaust gasket 6
Exhaust gas leaks → Replace.
Tightening torque 7
Bolt (exhaust pipe) 7:
27 Nm (2.7 m • kg, 19 ft • lb)
Springs
Refer to "EXHAUST ASSEMBLY" in CHAP-
TER 5.