EY3551-U1 / EY3552-U1
Ref. No. 3F
Procedure 3A → → → → 3B → → → → 3C → → → → 3D → → → → 3E → → → → 3F Assembly of the shoe.
Great user manuals database on
1. Insert the spring pin with a rod having a diameter of 5mm.
NOTE:
2. Place the toothed lock washer inside and the stopper washer to
the housing B.
3. Sliding the depth adjustment plate up with placing the stopper
washer into the ditch of the depth adjustment plate.
4. Pass the square screw through.
5. Insert the pipe and place the spring wahser and piling catahats
washer from housing A side with holding the square screw by hand.
6. Insert the hex nut and the shoe up (parallel to the main body).
7. Tighten the hex nut with the depth adjustment lever at 30kgfcm.
8. Set the depth adjustment lever.
NOTE:
9. Attach the NEW E-ring with pliers.
NOTE:
10
UserManuals.info
Make sure that the slit part of spring is placed downward. And
protrusion of spring pin should be uniform on both side.
Make sure that the depth adjustment lever is set about 14mm
away from housing. If the gap between housing and lever is less
than 14mm, take the lever out and turn 30degree toward your
side and try to set again.
Please use the new E-ring every time disassembling the depth
adjustment lever assembly.