Table of Contents
Advertisement
10.3 Maintenance schedule planetary gearbox
The material number-specific operating instructions may include a maintenance
schedule which is different from the maintenance schedule in the general
operating instructions. The maintenance schedule in the material number-
specific operating instructions always applies.
Check whether there is a different maintenance schedule for your planetary
gearbox in the material number-specific operating instructions.
The maintenance schedule, shown in table 6 "Maintenance schedule planetary
gearbox" only applies for the planetary gearbox. Therefore observe not only
with the maintenance schedule of the planetary gearbox but also with the
maintenance schedule included in the machine/vehicle manufacturer's
operating instructions.
Table 6
Maintenance schedule planetary gearbox
Interval
After 150 motor
operating hours
Daily
Weekly
Monthly
Every six months
Every year, however not
later than after 1500
motor operating hours
10.4 Maintenance
If used in accordance with the intended purpose, the planetary gearbox is low-
maintenance.
The service life of the planetary gearbox essentially depends on the quality of its
lubricating oil. We therefore recommend changing the lubricating oil at least once
a year or every 1,500 operating hours (whichever is earlier).
RE 79039-01-B/01.2021, MOBILEX GFB 8000 series 40 general operating instructions, Bosch Rexroth AG
Action
Perform the first oil change.
Perform noise test
Perform visual inspection
Perform oil level check
Check that the planetary gearbox
mounting screws are tightly secured
With existing grease nipple Use
lithium multi-purpose grease L-
XBCHA3 (GB 7324-94) or FAG
Arcanol MULTI3 or Klüberplex BE 31-
222 to grease the lubricating point
(output shaft)
Perform oil change.
Servicing and repair
49/64
NOTE
refer to chapter 10.4.2
refer to chapter 10.2.3
refer to chapter 10.2.1
refer to chapter 10.2.2
If necessary, retighten
mounting screws
If the bearing of the output
shaft in the output shaft
housing is grease-
lubricated, there is at least
one grease nipple on the
output side that you
should use to relubricate
the bearing.
refer to chapter 10.4.2
Advertisement
Table of Contents
