Table of Contents
Advertisement
•
Momentary Press
•
Press and Hold
Reset
•
Cold Boot
•
The Press and Hold, Reset, and Cold Boot options are not available when the server is powered off.
3. When prompted to confirm the request, click OK.
Virtual power button options
Momentary Press—The same as pressing the physical power button. If the server is powered off, a momentary press
•
will turn on the server power.
Some operating systems might be configured to initiate a graceful shutdown after a momentary press, or to ignore
this event. Hewlett Packard Enterprise recommends using system commands to complete a graceful operating system
shutdown before you attempt to shut down by using the virtual power button.
•
Press and Hold—The same as pressing the physical power button for 5 seconds and then releasing it.
The server is powered off as a result of this operation. Using this option might circumvent the graceful shutdown
features of the operating system.
This option provides the ACPI functionality that some operating systems implement. These operating systems behave
differently depending on a short press or long press.
•
Reset—Forces the server to warm-boot: CPUs and I/O resources are reset. Using this option circumvents the graceful
shutdown features of the operating system.
Cold Boot—Immediately removes power from the server. Processors, memory, and I/O resources lose main power. The
•
server will restart after approximately 8 seconds. Using this option circumvents the graceful shutdown features of the
operating system.
iLO access settings
The default access settings values are suitable for most environments. The values you can modify on the Access Settings
page allow customization of the iLO external access methods for specialized environments.
The values you enter on the Access Settings page apply to all iLO users.
Service settings
You can configure the following settings in the Service section on the Access Settings page.
Secure Shell (SSH)
Allows you to enable or disable the SSH feature.
SSH provides encrypted access to the iLO CLP.
Secure Shell (SSH) Port
Sets the SSH port. The default value is 22.
Web Server
Allows you to enable or disable access through the iLO web server.
Set up HPE iLO on the HPE ProLiant e910t Server Blade
28
Advertisement
Table of Contents
