Section 6 - Accelerator And Brake Pedal Assemblies; Accelerator Pedal Removal - Husqvarna HUV4420 Service Manual

SECTION 6 – ACCELERATOR AND BRAKE
PEDAL ASSEMBLIES
ý
DANGER
• See General Warning, Section 1, Page 1-1.
ý
WARNING
• See General Warning, Section 1, Page 1-1.
ACCELERATOR PEDAL
See General Warning, Section 1, Page 1-1.

ACCELERATOR PEDAL REMOVAL

1. Turn the key switch OFF, and place the Forward/Reverse handle in the NEUTRAL position. Remove the
key. Chock the rear wheels.
2. Disconnect the battery cables as instructed. See WARNING "To avoid unintentionally starting..." in
General Warning, Section 1, Page 1-1.
3. Remove the dashboard. See Dashboard Removal on page 4-4.
4. Disconnect the cable strain relief from the pedal bracket.
5. Disconnect the Z-shaped end (1) of the accelerator cable from the pedal (Figure 6-1, Page 6-1).
Figure 6-1 Z-Shaped Cable End (Gasoline Vehicles)
6. Remove the pedal assembly bolts and lock nuts that secure the pedal assembly to the frame.
7. Slide out and twist the pedal to remove the pedal assembly from the frame.
8. Inspect the pedal bushings for wear and replace pedal assembly if worn.
9. Inspect the pedal and return spring hub bushings for excessive side-to-side movement. Replace the
pedal assembly if either or both show signs of excessive wear.
2005 HUV4420 Gasoline and HUV4420-D Diesel Vehicle Maintenance and Service Manual
1
6
Page 6-1