Hitachi GR4000 Series Quick Start Manual page 25

Setup of GR4000-80E2
●Setup procedures
6.
Procedure
Check LED
4.
Procedure
Attach an
interface cable.
2.
Procedure
Install a memory
card.
Figure 2-3 Procedures for GR4000-80E2 setup
1.
Procedure
Attach a power cable.
Attach power cables to all the power supply units in GR4000-80E2.
GR4000-80E2 requires DC cables. See the GR4000 Hardware Installation Guide if you want to know how to attach DC cables.
2.
Procedure
Install a memory card.
Insert a memory card into both the memory card slot 0 and the memory card slot 1 of a basic control unit (BCU0).
Caution While the access indicator of BCU (ACC lamp) is lit, the memory card is being accessed. DO NOT
pull out a memory card or turn off the power switch while the memory card is being accessed. If
so, you could permanently damage the memory card.
NOTE When inserting a memory card, the surface labeled with the part number "HN-F9244-66X" should
be faced up.
NOTE Use a standard type of memory card provided by HITACHI. The operation cannot be guaranteed if
a memory card other than that is used.
When installing a memory card using an option license for GR4000, make sure that the
manufacturing number of a device put on the label of a memory card matches the serial number
of an option license. (You can check these numbers using a packing list provided with GR4000.)
3.
Procedure
Connect a setup terminal to GR4000-80E2.
1．
Connect a setup terminal to the CONSOLE port of BCU (BCU0) using a RS－232C cross cable.
2．
Start up a setup terminal.
3．
Start up communication software.
NOTE As for the setup of communication software, see the communication software manual.
4.
Procedure
Attach an interface cable.
Attach an interface cable to an interface port.
QSGGR4K00-10 5794047-1X
GR4000 Quick Start Guide, Revision 1 - Preliminary
Procedure
Procedure
3.
Procedure
Connect a setup terminal
to GR4000-80E2.
1.
Attach a
power cable.
5.
Power on
GR4000-80E2.
9