GE GTDN500EMWS Installation Instructions Manual page 6

GARAGE INSTALLATION (IF ALLOWED
9
BY LOCAL CODES)
10
DRYER EXHAUST TO RIGHT, LEFT
OR BOTTOM CABINET
WARNING -
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR HANDS
AND ARMS FROM SHARP EDGES WHEN
WORKING INSIDE THE CABINET. BE SURE TO
WEAR GLOVES
REMOVE
SCREW
AND SAVE.
Detach and remove the bottom, right or left side knockout
as desired. Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer.
Note: Only 4" round rigid metal ducting allowed inside
dryer.
B
Cut the duct as shown and keep portion A.
TAB LOCATION
BEND TAB
o
UP 45
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45º using a flat
blade screwdriver.
Installation Instructions
BEFORE PERFORMING
REMOVE
DESIRED
KNOCKOUT
(ONE ONLY).
FIXING HOLE
A
9"
ADDING NEW DUCT
FIXING
HOLE
PORTION "A"
RIGHT OR
LEFT SIDE
EXHAUST
Reconnect the cut portion (A) of the duct to the blower
housing. Make sure that the shortened duct is aligned with
the tab in the base. Use the screw saved previously to secure
the duct in place through the tab on the appliance base.
ADDING ELBOW AND DUCT FOR
EXHAUST TO LEFT OR RIGHT SIDE OF
CABINET
CAUTION:
Be sure not to pull or damage the
electrical wires inside the dryer when inserting the
duct.
EXHAUST CAN
BE ADDED TO
LEFT OR RIGHT SIDE
6
DUCT
TAPE