GE GTDN500GMWS Installation Instructions Manual
Ge® 7.0 cu. ft. stainless steel capacity gas dryer with sensor dry™
Hide thumbs
Also See for GTDN500GMWS:
- Owner's manual (32 pages) ,
- Dimensions and installation information (3 pages)
Advertisement
Quick Links
Download this manual
See also:
Owner's Manual
Installation
Instructions
EFORE O
EGIN
Read these instructions completely and
carefully
IM ORTANT
IM ORTANT
Note to Installer
Note to ustomer
TOOLS YOU
WILL NEED
(x2)
10" ADJUSTABLE WRENCHES
8" PIPE WRENCH
SLIP JOINT PLIERS
FLAT BLADE SCREWDRIVER
uestions on Installation
California Safe Drinking Water and Toxic Enforcement Act.
DO NOT
In the state of Massachusetts:
Insta at on ust e e fo
u
When us n
A e
4" DIA. METAL DUCT
(RECOMMENDED)
4" DIA. FLEXIBLE METAL (SEMI-RIGID)
UL LISTED TRANSITION DUCT
(IF NEEDED)
KIT WX08X10077 (INCLUDES 2 ELBOWS)
LEVEL
4" DIA. FLEXIBLE METAL (FOIL TYPE)
UL LISTED TRANSITION DUCT
(IF NEEDED.)
Gas Dryer
all:
GE ARES
www.GEAppliances.com (US)
WARNING
RISK OF FIRE
e
e o
as tte
ua e o cense
a t e as shut off a es the sha
e as connecto
hen use
M ATERIALS YOU WILL NEED
4" DIAM METAL ELBOW
(x2)
4" DUCT CLAMPS
OR
4" SPRING CLAMPS
(x2)
234D1582P003
S
a ua e o cense cont acto
the state
e T han e t e
ust not e cee
feet
PIPE
EXHAUST HOOD
COMPOUND
SOAP SOLUTION
FOR LEAK DETECTION
DUCT TAPE
SAFETY GLASSES
FLEXIBLE GAS LINE CONNECTOR
31-16225-2 03-12 GE
GLOVES
Advertisement
Related Manuals for GE GTDN500GMWS
Summary of Contents for GE GTDN500GMWS
-
Page 1: Gas Dryer
T han e t e hen use ust not e cee feet PIPE EXHAUST HOOD COMPOUND SOAP SOLUTION FOR LEAK DETECTION (x2) DUCT TAPE SAFETY GLASSES (x2) FLEXIBLE GAS LINE CONNECTOR 31-16225-2 03-12 GE GLOVES... -
Page 2: Installation Instructions
Installation Instructions Minimum learance Other Than Alco e or loset Installation must RE ARING FOR INSTA ATION OF NEW DRYER TI : Install your dryer efore installin your asher This ill allo etter access hen installin dryer e haust DISCONNECTING GAS TURN GAS DISCONNECT AND DISCARD OLD SHUT-OFF VALVE... - Page 3 Installation Instructions RECONNECTING GAS Listed connector ANSI Z21.24 / CSA 6.10 FLARE 3/8" NPT Note: CA TION TIGHTEN THE FLEXIBLE GAS LINE USING TWO ADJUSTABLE WRENCHES. 1/8" NPT PIPE PLUG FOR CHECKING GAS INLET PRESSURE PIPE SIZE AT LEAST 1/2" TIGHTEN ALL CONNECTIONS USING TWO ADJUSTABLE WRENCHES.
- Page 4 Installation Instructions E ECTRICA CONNECTION INFORMATION WARNING TO RED CE T E RISK OF FIRE E ECTRICA S OCK AND ERSONA IN DO NOT SE AN E TENSION CORD OR AN ADA TER G WIT T IS A IANCE E ECTRICA RE IREMENTS WARNING THIS DRYER IS...
- Page 5 Installation Instructions E HA ST CONNECTION WARNING TO RED CE THE RISK OF FIRE OR ERSONA IN THIS DRYER COMES READY FOR REAR E HA STING IF S ACE IS IMITED THE INSTR CTIONS IN SECTION TO E HA ST DIRECT Y FROM THE SIDES OR OTTOM OF THE CA INET STANDARD REAR EXHAUST (Vented at floor level)
- Page 6 Installation Instructions CONNECTING THE DRYER TO HO SE ENT RIGID META TRANSITION D CT ISTED F E I E META SEMI RIGID TRANSITION D CT ISTED F E I E META FOI TY E TRANSITION D CT ELBOW HIGHLY RECOMMENDED ELBOWS HIGHLY RECOMMENDED DON’T...
- Page 7 Installation Instructions GARAGE INSTA ATION IF A OWED BY OCA CODES DRYER E HA ST TO RIGHT EFT OR BOTTOM CABINET WARNING BEFORE PERFORMING THIS E HA ST INSTA ATION BE S RE TO DISCONNECT THE DRYER FROM ITS E ECTRICA S PP Y PROTECT YO R HANDS AND ARMS FROM SHARP EDGES WHEN WORKING INSIDE THE CABINET BE S RE TO WEAR G O ES...
- Page 8 Installation Instructions ADDING E BOW FOR E HA ST THRO GH BOTTOM OF CABINET CAUTION: Internal duct joints must be secured with tape, otherwise they may separate and cause a safety hazard. ADDING CO ER P ATE TO REAR OF CABINET PL ATE (KIT WE1M454)
- Page 9 Installation Instructions CONNECTING IN ET HOSES (on some models) NOTE: NOTE: CONNECTING IN ET HOSES cont WATER S PP Y RE IREMENTS NOTE: SER ICING WARNING ABE A PRIOR TO DISCONNECTION WHEN SER ICING CONTRO S WIRING ERRORS CAN CA SE IMPROPER AND DANGERO S OPERATION AFTER SER ICING INSTA ATION GEAppliances.com...
- Page 10 Notes...
- Page 11 Notes...