Creating Your Own Sound Mode - Manual Mode - JVC MX-G75VUN Instructions Manual

Creating Your Own Sound Mode
— Manual Mode
You can change SEA patterns to suit your preference. These
changed settings can be stored in the MANUAL 1,
MANUAL 2, and MANUAL 3 modes.
• There is a time limit in performing the following steps. If
the setting is canceled before you finish, start from step 1
again.
On the unit ONLY:
1
Select one of the preset sound modes.
• If you want to add the surround elements in your SEA
pattern, select one of the surround modes (D.CLUB,
HALL, or STADIUM) before starting the procedure
below. (See "Selecting the Sound Modes" on page 10.)
2
Press and hold SET/DISPLAY
until "SEA CONT" appears on the
display.
3
Adjust the SEA pattern.
1) Turn 4/¢ to select the
frequency range to adjust
(LOW, MID, HIGH).
2) Press 1 or ¡ to adjust
the level (–3 to +3) of the
selected frequency range.
3) Repeat steps 1) and 2) to
adjust the level of the other
frequency ranges.
Current level appears.
– 11 –
4
Press SET/DISPLAY again.
5
Turn 4/¢ to select one of
the MANUAL 1, MANUAL 2,
and MANUAL 3 modes into
which you want to store the
SEA pattern.
6
Press SET/DISPLAY again.
The SEA pattern you have created are stored into the
MANUAL mode selected in the above step.
To use your own sound mode
Select MANUAL 1, MANUAL 2, or MANUAL 3 mode
when using the sound modes. See "Selecting the Sound
Modes" on page 10.
When you unplug the AC power cord or if a power failure
occurs
The setting will be erased in a few days. If this happens, set the
manual sound modes again.