JVC CU-VD40 Copying Manual

IMPORTANT
Please read carefully before use.
1. Get ready a recommended disc
Please use the recommended discs stated below.
Using discs other than those recommended may cause problem when copying to the DVD
and when playing back the DVD.
Recommended discs
DVD-R
Brand JVC JVC
TDK
Verbatim
SONY
Caution
•
Only DVD-R and DVD-RW discs can be used.
•
DVD-R DL (single-sided double layer) discs can only be used for High definition Everio.
•
Recording and playback may not function properly if the recording side is scratched or dirty.
2. Set up each device before copying
High definition
Everio
Dedicated USB cable
3
1
Connect the USB cable
2
Turn on CU-VD40
After turning on the power, wait for approximately 20 seconds before
proceeding to step .
3
The burner may not function properly within this 20 seconds.
3
Turn on the Everio
•
The power lamp of CU-VD40 turns from orange light to green light.
4
Insert a new recommended disc into CU-VD40
Next, operate the Everio. Proceed to step 3.
Easy and correct way of copying to a DVD
(See overleaf on playing back the DVD)
DVD-R DL
DVD-RW
(single-sided double layer)
JVC
Verbatim
CU-VD40
1
4
2
3. Copy all images to the DVD
Perform operations on the Everio.
1
Confirm that the display on the right
appears on the Everio LCD screen.
2
Select "NORMAL BACK-UP"
1 Select
(move up and down)
2 Confirm
(press down)
3
Select "ALL"
1 Select
(move up and down)
2 Confirm
(press down)
4
Select "EXECUTE AND FINALIZE"
1 Select
(move up and down)
2 Confirm
(press down)
•
Playback is not possible if the disc is not
finalized.
•
Wait for the "copy in progress" screen on the
right and the "hourglass" mark to disappear,
then turn off the power and disconnect the
USB cable.
5
Exit
Confirm
(press down)
Note
•
There are other ways of copying which includes copying only the desired files.
For details, refer to the instruction manual of Everio.
CU-VD40
(Everio LCD screen display)
"Copy in progress" screen
Copying completed!
LYT1752-013A
0707MNH-SW-BJ