Hitachi GS4000 Series Quick Start Manual page 28

Hide thumbs Also See for GS4000 Series:
Table of Contents

Advertisement

GS4000 Quick Start Guide, Revision 3
3.1 Setup of GS4000
3.1 Setup of GS4000
In this section, you can learn how to set up GS4000.
The setup of GS4000 should be done according to the following procedures.
NOTE
Skip to the chapter "4. Operations for Initial Introduction of System" in case that you consigned
the setup of GS4000 to our local service staffs in your region
Setup of GS4000-80E1
●Setup procedures
6.
Procedure
Check LED.
4.
Procedure
Attach an
interface cable.
2.
Procedure
Install a memory card.
Figure 3-1 Procedures for GS4000-80E1 setup
Procedure 1.
Attach a power cable.
Attach power cables to all the power supply units in GS4000-80E1.
When connecting the device to a power supply unit, use only grounded
Warning
power outlets. Failing to use grounded outlets creates a shock hazard.
Use the power cable provided with a chassis. If you use a power cable other
Warning
than this, it could cause a fire or an electric shock.
Before attaching a power cable, make sure that all the switches of GS4000 are
NOTE
turned OFF.
10
1
.
Procedure
Attach a power cable.
Procedure
3.
Procedure
Connect a setup terminal
to GS4000-80E1.
QSGGS4KX10-00 5794092-2X
5.
Power on GS4000-80E1.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents